SOLD-SOLD- SOLD Demeter – Minnie VTBP-M-800D Amp £900

[Oldman]

[font=arial,helvetica,sans-serif]Due the band being in recess and me having more heads than I need, this miniscule piece of all American Electrickery weighing in at 10.5 lbs and measuring only 13”wide x 5.5”high x 9”deep, is FOR SALE. it is number 31 of the initial limited run and signed by James Demeter himself. No issues with it at all it sits waiting for a new owner.

Comes complete with an expensive Roqsolid padded gig bag (£89.00)

It punches out 800 Watts at 4 Ohms with subtlety. I have used it with a 2 cab (15") Tecamp setup, a single 18" (phwoar) and a single 2 x 10 it never fails to impress. Used on three gigs and about 6-7 rehearsals it is a lovely piece of KIT.

It has an all tube pre-amp circuitry Hand wired in the USA using High quality components, DC filament, full 280V high voltage supply. Classic passive tube tone controls Treble, Middle, Bass with frequency selector and presence with frequency selection. [/font][list]
[*][font=arial,helvetica,sans-serif]Treble Control: The treble control gives 6 dB of boost or cut at 4 kHz (6dB per octave, shelving type).[/font]
[*][font=arial,helvetica,sans-serif]Middle Control: The middle give 6dB of boost or cut at 500Hz (wide Q, peaking type).[/font]
[*][font=arial,helvetica,sans-serif]Bass Control: The bass control gives 9dB of boost or cut at a selectable frequency of 60Hz or 120Hz (6dB per octave, shelving type).[/font]
[*][font=arial,helvetica,sans-serif]Presence Control: The presence control gives up to 12dB of boost at a selectable frequency of 2kHz or 4kHz (active type, 6dB per octave).[/font]
[*][font=arial,helvetica,sans-serif]Mode switch: Dark, is a high frequency cut fattening up your fundamental. Normal, flat operation showing off more overtones. Bright, brings out the overtones on the dullest basses or speakers.[/font]
[*][font=arial,helvetica,sans-serif]Internal Volume Trimmer: This control is designed to match the output volume of the VTBP-M-800D with the sensitivity of any Bass.[/font]
[/list][list]
[*][font=arial,helvetica,sans-serif]Outputs (power amp): 1/4” Speaker & Speakon[/font]
[*][font=arial,helvetica,sans-serif]Output impedance (power amp): 4 ohm, 8 ohm, 16 ohm[/font]
[*][font=arial,helvetica,sans-serif]Output Power (power amp): 800 watt RMS @ 4 ohms, 400 watt RMS @ 8 ohms[/font]
[/list]
Front of Demeter
[attachment=195424:Front of Demeter 2.jpg]

Rear of Demeter
[attachment=195425:Rear of Demeter.jpg]

Number 31
[attachment=195426:Demeter Issue 31.JPG]

Thanks For Looking!

Edited July 3, 2015 by Oldman

[Bigwan]

May I be the first to say... Your choice of font is truly dreadful.

Good luck with selling this beast though!

[Oldman]

Thank you, when did you join the "Font Police"? My first reaction was to PM you and the other 'editing' clown to FO, I didn't, I did change the font though.

IMO, comments on post's, helpful, good, bad, indifferent or critical should be kept to PM's for action or not by the member listing the item. Comments (IMO) should address the salient features of the item for sale and not the manner in which it is written.


Thanks for looking

PS: I could be interested in a part chop/partial trade for lightweight cabs of the 1x12 variety, must be as new with provenance!

Edited July 1, 2015 by Oldman