bigevilman

No one got any recommendations?

Hi I need a new wiring harness for my bass cab - need jack to a single 15" for an 8 ohm speaker. Anyone got any recommendations? Much appreciated 🙂 Joe

Hi guys Need a bit of advice - occassionally my Eden D210xlt makes crackling noises from the tweeter. I've had the back out, and all the connections look fine. As it's only occasionally, I'm thinking the bulb/fuse like thing in the crossover is faulty, which I'm thinking I should replace before I try looking at replacing the tweeter/crossover. Does anyone know where to buy these from? Be much appreciated 😊 Cheers Joe

Looking over the top, it looks like the body is a 3 piece, and the pieces are just separating as its following the line of the wood. I'd go to a local luthier to get it assessed, but in the current climate, that's not possible. Going to use it as a haggling point, but just wanted to make sure it's not gonna cost me a lot later down the line! Plays lovely

Morning All My friend has lent me his 78 jazz, with the opportunity to buy. It plays and sounds lovely, but whilst inspecting, I noticed this crack within the neck pocket. Should this be something I should be worried about? Also, what would be the repair solution? Cheers Joe

My main go to has been my squier VM 5 string P for a while. When I bought it, it had already been upgraded with hipshot tuners and American pickups. It's due a string change, so whilst I'm getting it setup, I'm thinking about treating it to an upgrade. Looking for ideas for bridges and whether a preamp would be worth doing, or upgrading to a Kiogon loom (think I've spelt that right?!?!) Any ideas welcome

Cheers for this Balcro. I assume the Sovereign 400lf wont match the cab? Only asking as that's more readily available, and I probably will never need the full 600 watts!

And internal port length is 195mm

Morning all Dimensions are 565mm height x 565mm width x 460mm depth. Port is 40mm up from bottom, with port 130mm in diameter. Hope this helps Cheers

Cone is stiff and smells burnt, and no resistance across the driver - practically no volume coming out, and when cranked goes distorted...no louder than a laptop speaker! The 210 I would say are factory standards...tbh I haven't pulled them out. I believe they're pre-Marshall takeover.