mikegrovesmusic

Hi, I’m selling my Aguilar Octamizer version 2. Well looked after and very little use. £185 price includes UK Postage. Here’s a bit of info from Aguilar: AN ALL-ANALOG OCTAVE PEDAL THAT CREATES A WIDE RANGE OF MUSICAL SOUNDS AN OCTAVE BELOW YOUR BASS SIGNAL. Modeled with old school and new school needs in mind, the Octamizer features independent volume controls for both the Clean and Octave sounds. This makes dialing in the exact amount of each a cinch. The two discrete signal paths also have their own tone controls that were specifically designed to enhance and expand their musical possibilities. The CLEAN TONE control uses a full spectrum tilt EQ, allowing for the boosting of treble while cutting bass or boosting of bass while cutting treble. This unique circuit allows you to create a clean sound that creates an octave doubling effect or to blend the sounds together for a great thick, snarky synth tone. *Pedal powered by universal 9-volt power supply only. Not included. Proprietary detector circuit for superior tracking Continuously variable multipole low-pass filter for Octave sound Dual filter architecture Full spectrum tilt EQ for clean sound Pedal powered by universal 9-volt power supply only. Not included. Cheers! Michael

Hi, I’m selling my Darkglass B3K. Well looked after and sounds great. I’m just not using it anymore. £160 price includes UK Postage. Here’s some info from Darkglass: An intuitive format that contains brutality and clarity at the same time is what the B3K delivers. A defined and powerful overdrive, with a simple layout, it sets no boundaries or rules to unleashing the desired tone. Blend Mixes the clean input signal with the overdriven signal. The clean signal remains at unity gain while the volume of the overdriven signal is set by the Level knob, allowing for fine control of the blend ratio. Tone Controls the high frequency content of the sound. A variable low pass filter from 3kHz (ccw) to 8kHz (cw). Level Sets the volume of the overdriven signal. Drive Sets the amount of saturation in the overdriven signal. Grunt When engaged provides a massive low end boost to really thicken your sound. Mid Boost Gives a subtle 6dB boost from 300 Hz to 1kHz to help you cut through a bit more. Output Connect from the ¼” Output jack to the input of your amplifier or another effects pedal. Input Connect your instrument or output from your pedal board to the ¼” mono jack. 9V DC Only use a regulated 9V DC adapter with a center-negative plug. Dimensions Width: 75 mm / 3″ Length: 111 mm/ 4¼″ Height: 43 mm / 1¾″ Weight: 250 g / 0.55 lb Warning The Microtubes B3K has a current draw of 20mA. Only use a regulated 9V DC adapter with a center-negative plug. Unregulated power supplies and/or higher voltages may result in suboptimal noise performance and even damage your unit, voiding the warranty. Thanks, Michael

Hi, I’m selling this set of Aguilar 5 string Jazz Bass pickups (AG 5J-HC) The pickups are brand new and have never been installed or used. £235 price includes UK Postage. Here’s some info straight from Aguilar: ‘THE WARM, PUNCHY TONE OF OUR 60'S ERA JAZZ BASS PICKUP, BUT WITHOUT THE 60-CYCLE HUM, IN A 5-STRING VERSION. Noise-free, classic Jazz Bass tone in a pickup that works great for all playing styles. Featuring our split-coil design, these pickups deliver a deep low-end, rich midrange character, and clear articulation – all with no hum! The AG 5J-HC pickup set is a direct replacement in the Fender Jazz V and many other 5 string J-style basses. Wire: 44 gauge, polyester-nylon wire Magnets: Alnico V Leads: Single conductor, heat resistant Teflon® coated’ Thanks! Michael

Hi, I’m selling my TC Electronic BH800 head with Footswitch. £270 Price includes UK Postage. Here’s some info straight from TC: BH800 Tech Specs Input connector - 1/4" jack Input impedance -500 kOhm / 100pF Gain range - -96 to 41dB Tone control: Bass 50 Hz @ Gain -24 to 0 dB; 80 Hz @ Gain 0 to +24 dB Tone control: Low Mids 200 Hz @ Gain -24 to 0 dB; 160 Hz @ Gain 0 to +24 dB Tone control: High Mids 630 Hz @ Gain -24 to 0 dB; 800 Hz @ Gain 0 to +24 dB Tone control: Treble 1800 Hz @ Gain -24 to 0 dB; 4000 Hz @ Gain 0 to +24 dB Tuner - Bass Tuner, always on Tuning range - B0 (30.87 Hz) to C4 (523.25 Hz) Mute - Mutes speaker output, phones output and balanced output Master level / Headphones output Studio quality headphone amp Recommended HP impedance 32 to 600 Ohm Mains supply 100 to 240 V~ 50/60 Hz (200 W @ 1/8 of maximum output) Power module rating - 800 W Speaker output Industry-standard 4-pole twist-lock speaker connectors Balanced output - Balanced XLR, pre/post preamp Balanced output maximum +2 dBu Bal. output optimal load impedance 600 Ohm Rehearsal input 1/8” jack input, fits to iPod® Humidity Maximum 90 % non-condensing Dimensions 275 x 69 x 279 mm / 10.8” x 2.7” x 11.0” Weight 3.0 kg / 6.6 pounds Finish Brushed and anodized aluminum front plate, metal chassis Cheers! Michael

SOLD Hi Everyone, I’m looking to sell my Pedaltrain Metro 20 with hard case. Price includes UK postage. It’s been toured quite a bit so the hard case has dents and scratches all over. But it’s still strong and secure. The actual board is in good condition, a few marks but nothing that noticeable really. The loop part of the Velcro is stuck to top and bottom of the board. Comes with keys. Size from Pedaltrain website: Metro 20 Pedal Board Dims: 20 in x 8 in x 1.4 in (50.8 cm x 20.3 cm x 3.5 cm) Wt: 1.7 lbs (.76 kg) Hard Case Ext Dims: 21.25 in x 10 in x 6.25 in (54.6cm x 25.4 cm x 15.8 cm) Int Dims: 20.25 in x 8.5 in x 4.75 in (51.4 cm x 21.5 cm x 12 cm) Wt: 5.4 lbs (2.46 kg) I’m only selling because I needed a bigger board and have bought a Metro 24. I’ll re-use the cardboard box for this to ship so don’t be concerned when a Metro 24 box shows up! Cheers, Michael

Hi, yes it’s still available.

Reduced to £1000 plus postage at buyers expense. Hi Everyone, I’m looking to sell my American Performer Mustang Bass with the limited edition, satin honey burst finish. This bass was bought brand new last year. I spent a lot of time trying to find one of these basses with good book matching, as many that I had seen were awful. I personally think that this example is very well matched. I’m happy to send more photos too. It’s had minimal use on less than a handful of gigs and mainly used at home. The condition is great, there’s just a small ding on the neck plate (photo below) which I think has been there from purchase. This was an impulse buy and it’s just not getting any use since I mainly play 5 string basses and rely on a low B for the type of gigs I play. The bass also comes with a fender soft case. It would benefit from a string change too. I’d prefer collection from south Birmingham, but could possibly meet up somewhere in the midlands. I could also arrange delivery at the buyers expense, I have an old heavy wooden p bass hard case that I could possibly send it in. I’m happy to get you a quote for shipping. Here’s some generic info taken from the web: ‘The American Performer Mustang Bass includes the Yosemite™ split-coil Mustang Bass middle pickup and a growling Yosemite single-coil Jazz Bass bridge pickup, designed for rich, expressive tones. With flat-staggered pole pieces to increase output and a shellac coating that lets the coils breathe while controlling feedback, Yosemite pickups produce dynamic sounds ideal for any musical situation. The American Performer Mustang Bass also features Greasebucket™ tone circuitry that lets you shape your highs without adding bass, preserving your sound. The “Modern C”-shaped neck sports a 9.5”-radius fingerboard that’s comfortable for almost any playing style, along with 19 medium-jumbo frets for effortless and accurate bending.’ Thanks for looking! Michael.

SOLD Reduced to £350 (plus postage at buyers expense) Hi Everyone, I’m selling my MarkBass Traveler 102p, 8ohm 400watt bass cab w/soft cover. I bought the cab new last year and it’s had some light use over a period of about 4 months. It’s in great condition, but a few of the plastic corners are a bit scuffed (photos below). It’s been kept in the MarkBass protection sleeve since I bought it. I took the MarkBass branding off the front because I was using the cab vertically and didn’t like the look of it being sideways. It can be easily glued back on. Collection is preferred from south Birmingham. I could potentially meet somewhere to drop it off around the midlands too. I can arrange delivery at the buyers expense too. Thanks for looking, Michael

It has both!

Withdrawn Hi Everyone, Selling my Tech 21 SansAmp Bass Driver DI V2. It’s in fantastic condition with no signs of wear, bought new in March. There’s just some Velcro attached to the bottom. It’s a fab bit of kit. Only moving it on because I’m using a different preamp di now and the Sansamp isn’t getting the use it deserves. The extra features from the previous version of the bass driver are a real game changer for this pedal. Comes with original box and all the papers/stickers etc. Price includes UK postage. Cheers! Michael