CameronJ

[quote name='No. 8 Wire' timestamp='1503403788' post='3357905'] If you're going the rechargeable battery/converter route then I would have thought a dedicated battery is the cheapest way to go - if the smooth hound will run off it. I have a line 6 M5 (500mA draw) that my battery system will not run, even though it should be within spec - all my pedals turned on at once are fine and that should be a 400-500 mA draw. That said, the M5 does seem so be particular about power supplies and also might have a start up spike that triggers the protection on the battery - its done the same with lower rated supplies before. Be good to know if something like a smooth hound with a high draw will run of one of these converter systems, even with a dedicated pack. [/quote] I suspect this is in part down to the fact you're using a USB battery pack with a 5v to 9v converter rather than a dedicated 9v pack. As you say the Line 6 M5 is quite fussy with power - I used to own one and it was always noisy when sharing power. That was before I really knew about the benefits of isolating pedals. [quote name='Happy Jack' timestamp='1503410046' post='3357992'] A-ha! There was me thinking that my Smoothhound just didn't like the battery pack ... it never occurred to me to try it with a battery pack on its own. Might have a play with that later. [/quote] You'll have no trouble with the Smooth Hound sharing a pack as long as you isolate it from the other pedals sharing the battery. My Smooth Hound is on the same pack as 5 other pedals and a Micro Thumpinator but works flawlessly running through a GigRig Timelord as isolation.

[quote name='EBS_freak' timestamp='1503322178' post='3357196'] The decision to not have centre negative on the Smooth Hound was always an odd decision to me. Anyway, re:Timelord... was looking into these... the Diago Isolator would have been a cheaper option... but it's still not a cheap option. [/quote] I looked into this at length and initially thought the same re: Diago Isolator, but the limiting factor is the amount of current each Isolator can supply. The Diago can only supply up to 110mA of current whereas the Timelord can supply up to 400mA I believe. The Smooth Hound needs around 300mA so the choice here is clear.

Don't see Maruszczyks on the 'bay very often: https://www.ebay.co.uk/itm/322661290569

I use a GigRig Timelord to isolate my Smooth Hound from the other pedals sharing the battery pack. Works like a charm. Had to put a little polarity reversing adapter on it though, as the Smooth Hound requires a centre-positive connection.

I don't have experience with the RH heads but I do own a BH800 and have to say it's brilliant. Unlike the controversy surrounding the advertised wattage of the RH series, the BH heads put out what they say on the box. They're clean, and uncoloured tone-wise with a really well thought out EQ section. Also, the TonePrint feature really isn't a gimmick - there are a lot of really nice sounding patches available which could genuinely remove the need for separate pedals for some people.

[quote name='GisserD' timestamp='1503146209' post='3356040'] The sfx loop logic pedal will do this. There's one for sale in the clasifieds atm. I know this because it's me selling it http://basschat.co.uk/topic/310317-effects-board-tuner-for-sale-aguilar-mxr-3leaf-mantic-korg-digitech/ [/quote] Ah, yes!

Give Bright Onion Pedals an email. They'll be able to build something to your exact spec, down to the colour of the LEDs in the enclosure. Http://www.brightonion.co.uk

[quote name='Stylon Pilson' timestamp='1503060563' post='3355405'] Yep, I'm using a Warwick Rockboard Power LT XL on a board with 5 pedals. It's awesome. The only small gripe I have about this particular model is that there's no on/off switch - the only way to turn it fully off is to disconnect it. S.P. [/quote] Yeah that isn't ideal...I think the Mooer and the Harley Benton have proper on/off buttons.

I use a couple of Warwick Rockboard Power LT XLs. Bit of a mouthful but they're basically the same thing as the Mooer. As long as you make sure they're charged when you need them, they're great. Obviously the more pedals you connect the greater the power demands and the faster it will discharge. Hence why I use two on my main board (over 10 pedals) and try to balance the current draw of my pedals between them so they run out at roughly the same time. Got myself a good wireless system (Smooth Hound) so as long as my power supplies are charged I only need one cable running from my board to the amp. Edit: Thomann do a Harley Benton equivalent which has a greater overall capacity but can allow slightly less current draw at any one time. Might be worth checking out.

[quote name='JazzBass4624' timestamp='1503047123' post='3355258'] Current chain adapter supplies 1300 mA which apparently is not enough for both stompboxes and BB. [/quote] 1300mA from the daisy chain is enough to power the three pedals, it's just the lack of isolation causing the issue. [quote name='bazztard' timestamp='1503048818' post='3355286'] I like the T Rex Fuel Tank JR. 5 outlets [url="http://www.t-rex-effects.com/fueltank-junior/"]http://www.t-rex-effects.com/fueltank-junior/[/url] [/quote] You won't be able to run the Beat Buddy off this though as none of the outputs supply a high enough current...

[quote name='dood' timestamp='1503001547' post='3355022'] Like my Shuker you mean? http://www.danveall.co.uk/shuker7/complete/16.jpg [/quote] That is porn. Does it feel as glossy as it looks?

The Beatbuddy is introducing noise because it's a fairly power hungry digital pedal and doesn't like sharing power with your other FX. The reason the noise goes away when you use the supplied power adapter is because it's isolated from your other pedals. In very basic terms it can't "see" them so it's happy Your solution would be to get an isolated power supply with several outputs . There are users here on Basschat who can recommend decent ones for not too much money. The benefit of a dedicated, isolated power supply is you'll have spare outputs left over should you invest in more pedals at some point in future. You'll have to double check that the supply is able to feed your Beatbuddy at least 350mA of power from one of its outputs. If you're absolutely certain you won't be getting any more effects then get something like a GigRig Timelord which will plug straight into one of the outputs on your existing daisy chain and allow you to isolate JUST the Beatbuddy on its own. Hope this helps!

I don't have a Super Compact but I do own a Tecamp Puma 900 and my only advice is don't sell your Puma!! I mean, if you get a Super Compact and somehow your Puma doesn't sound good through it then ok...but I think it'll sound great. Barefaced cabs are quite power efficient so don't worry about the head being "only 500 watts".

Ooh I'm jealous ped! Very cool.

[quote name='project_c' timestamp='1502921305' post='3354465'] I quite like that actually, would be nice on a pbass with a maple neck. Dodgem vibes. [/quote] Yes! That would look lovely. Also, dood, I have to admit I wasn't the biggest fan of the Ferrari yellow but I'm loving this new look! Great work.

There are loads of great options in this price range to be fair. Are you intending on using them primarily for casual listening or for studio/recording/mixing? By the sounds of your original post I'm assuming casual listening but thought I should ask just in case!

I realise that most threads seeking recommendations become a case of everyone suggesting what they use, but... For that money you should be able to get a used or refurbished pair of Sennheiser Momentum 2.0 Around Ears. Make sure they're wired though as the wireless ones will cost considerably more. I recently bought the wireless ones and they're seriously good. Got them refurbished through the Sennheiser outlet which basically meant I got a good as new pair of high end cans at a hefty discount, direct from Sennheiser with warranty. I listen to (mostly) neo soul, jazz and R&B and find them lovely sounding. Not noticeably hyped in any frequency range, just clear and balanced with good response from top to bottom. They're very well made and look great too if you care about aesthetics. The internet is full of adoring reviews of these so don't take my word alone, do a quick google search. Whatever you end up with though, my advice is not to buy new as you'll save a load of pennies going refurbed or used. But then that would be my advice for buying pretty much anything

[quote name='burno70' timestamp='1502468975' post='3351721'] Depends how spendy you want to be. After buying a Phil Jones Big Head I'm gassing for a Double Four. [/quote] Big +1 here. I missed out on one a little while ago and really regret not going for it. PJB make fantastic stuff. Although saying that, I've just acquired a Tecamp Puma 900 and so far have only played it through headphones - if it were practical to carry it around as a headphone amp it would knock the Big Head off the top spot! The tone shaping is so good.