bigevilman

No one got any recommendations?

Hi I need a new wiring harness for my bass cab - need jack to a single 15" for an 8 ohm speaker. Anyone got any recommendations? Much appreciated 🙂 Joe

Hi guys Need a bit of advice - occassionally my Eden D210xlt makes crackling noises from the tweeter. I've had the back out, and all the connections look fine. As it's only occasionally, I'm thinking the bulb/fuse like thing in the crossover is faulty, which I'm thinking I should replace before I try looking at replacing the tweeter/crossover. Does anyone know where to buy these from? Be much appreciated 😊 Cheers Joe

Looking over the top, it looks like the body is a 3 piece, and the pieces are just separating as its following the line of the wood. I'd go to a local luthier to get it assessed, but in the current climate, that's not possible. Going to use it as a haggling point, but just wanted to make sure it's not gonna cost me a lot later down the line! Plays lovely

Morning All My friend has lent me his 78 jazz, with the opportunity to buy. It plays and sounds lovely, but whilst inspecting, I noticed this crack within the neck pocket. Should this be something I should be worried about? Also, what would be the repair solution? Cheers Joe

My main go to has been my squier VM 5 string P for a while. When I bought it, it had already been upgraded with hipshot tuners and American pickups. It's due a string change, so whilst I'm getting it setup, I'm thinking about treating it to an upgrade. Looking for ideas for bridges and whether a preamp would be worth doing, or upgrading to a Kiogon loom (think I've spelt that right?!?!) Any ideas welcome

Cheers for this Balcro. I assume the Sovereign 400lf wont match the cab? Only asking as that's more readily available, and I probably will never need the full 600 watts!

And internal port length is 195mm

Morning all Dimensions are 565mm height x 565mm width x 460mm depth. Port is 40mm up from bottom, with port 130mm in diameter. Hope this helps Cheers

Cone is stiff and smells burnt, and no resistance across the driver - practically no volume coming out, and when cranked goes distorted...no louder than a laptop speaker! The 210 I would say are factory standards...tbh I haven't pulled them out. I believe they're pre-Marshall takeover.

Morning all I've recently got a old Eden D115 (non tweeter model). Its the model before the current D115xlt - it has a small circular port at the back. I came to play it and the speaker has completely gone. The original speaker was eden ec1560f (of April 1999 vintage). Has anyone got any recommendations for a suitable replacement speaker? Need an 8ohm model so i can use it with my 210. Cheers Joe

Cheers for confirmation bud 👌

It looks relatively new, so I'm assuming it's from the Marshall factory. Wanted one for years - shame I'm not gigging atm - time to join a new band!

Was browsing around eBay, looking for a TC combo when I came across this eden D210xlt. Managed to bag it for £150! Well chuffed 😁 now just waiting for TC bh250 to turn up and my home setup will be all sorted 🤘

Deffo look at the fane upgrade 😁

Cheers for feedback guys

Hi Guys Not gigged for the last couple of years so decided to downgrade my rig to a small home combo. Looking at the TC BG250 as I've had a TC head before and quite enjoyed it. Looking for people's opinion on the best speaker config - I know the 208 is the only one that has the BH250 head loaded in, but do the speakers stack up? Would love opinions