Majid

Thanks for the advice. I’ll do that after the holidays.

Hi Stevie, Thanks for the reply. Honestly I’m not specialised in that area so my preference would be a replacement of the faulty tweeter with the same model rather than building a new crossover and using a different tweeter. Are you saying if I replace the original diaphragm, it would be repaired? If that’s the case then it’d be preferable.

Thanks a lot for the explanation and for the schematics. Is the 0.4mH reactor/coil in the low pass circuit the same as the one in the high pass circuit?I mean do both circuits share the same coil? Because their ratings are pretty close.

Has the Eminence you recommended as enough clarity and presence as ST304-SLF does? And what crossover does it need? Where can I get the spec of that crossover to be specifically built?

Hi Bill, thanks for the reply. No, I don’t and that’s the issue. I like a clear and crispy high end (but not too thin) as I mostly slap on my 70’s jazz basses. Without a tweeter, the cab doesn’t sound the way I like. What would be the alternatives if I’m not able to find a new ST304-slf? Chatgpt suggested eminence APT80 v2 but I need to modify it to be able to mount it due to size difference.

Hello bass lovers, Happy new year 😊 I own an EBS HD350 head with EBS evolution proline 2000, 4x10, 800W with selenium st304-slf tweeter. I bought this rig second hand last year. As I was not experienced with the sound of EBS, I didn’t notice anything until I read (on the internet) about the hi-fi and special brightness/clarity of the EBS sound and also watches some videos. Then I started feeing that there is something wrong with my stuff. I recorded the amp directly and it sounded very clear and bright so no issue….Then I started looking into the cab by tweaking the high frequency selector switch on the back of the cab to boost the level of the tweeter but didn’t hear any difference. Then I opened the cab and listened to the tweeter closely but didn’t hear any sound coming out of it. I demounted the tweeter, disconnected the wires and measured the resistance. The ohm meter didn’t show anything. So, few questions: 1. Is there anyone with the same exp. here? 2. Am I guessing the issue correctly that the tweeter is faulty and need to be replaced? Or am I doing a wrong test and perhaps the issue is somewhere else? 3. Where can I find Selenium ST304-slf tweeter if the issue is with the tweeter itself? Thanks and best regards, Majid

I changed the eq set up a little by cutting more of mid range and here is the result attached: Please let me know if it has become closer to or farther from MM tone comparing to the tone in my video? Detroit - Marcus Miller back up (2) new tone.m4a

Thanks a lot for your nice words 🙏

And by the way, thanks a lot for your nice words 🙏

Thanks for your reply. I also thought about it but was not sure if it will make a big difference. But maybe it is worth trying

Thanks for your reply. No I haven’t tried those strings yet. I should give it a try soon

I connected the bass to Zoom multi effect to boost the signal a little bit then send it through scarlett 2i2 and recorded on Cubasis 3.

As you can see here I used eq twice before and after compression. But maybe I should lower the mids further and remove the second eq entirely as it is adding low mid up to 5,5 db?!

Thanks a lot 🙏🙏🙏