Jump to content
Why become a member? ×

Aria SB600/4 Fretless (lined) ... too late !!


eubassix
 Share

Recommended Posts

This was - or became - something of a project bass (when I discovered that the original pickup wasn't working fully). Tried for an original but hard-to-find and opted instead for a Bartolini W4CBC - Classic series.
Some stock photos/information etc. here:-
[url="http://www.matsumoku.org/models/ariaproii/bass/sb/sb.html"]http://www.matsumoku.org/models/ariaproii/bass/sb/sb.html[/url]
This is an 82 model with 3-pc. Maple set-neck, 24 fretlines, padauk-red tinted body (body is maple), brass bridge and nut, rosewood 'board, 1x Vol, 1x Tone + coil-tap switch.
The bass plays and sounds great but there's a distinct loss of volume when switching to SC - and the HB just sounds better anyway: not sure if this is the pickup (mis-match with Aria electronics?) or my wiring?!.. TBH, once I got it working well in HB I just didn't want to mess around any more (!). So it might be solve-able.
I did think of epoxy coating the f/board .. but the rosewood and FL tone is just too nice as it is.
But I did change the rather bright/fullgloss finish to a more subtle satin finish,.
No major marks or dings, but a few smaller ones here and there.
Comes with an OK gig-bag (hardcase might be hard/er to find as the body is big).
[b]sold[b]

Edited by eubassix
Link to comment
Share on other sites

  • 2 weeks later...
  • 4 weeks later...

Didn't sell on ebay .
Decided to BUMP this offer - had BC and local interest but no further response to PM's/emails .. so it's available again.

[b]No longer available [/b]

Edited by eubassix
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...