markstuk Posted December 16, 2010 Share Posted December 16, 2010 (edited) As per photo.. Complete rig including SKB 4U ABS case, recently serviced by Steve's Amp Repairs in Snow Hill in Brum.. Warwick Terminator cab includes Custom Warwick flight case (one catch slightly wonky, but case is fully serviceable nonetheless). This is a bi-amped setup with 500W going to the 2 x 15" drivers and 500W going to the 2 x 10"and horn.. Includes 4 way footswitch setup (2 x 2 way Ashdown footswitches) Looking for £600 all-in (collected from Stratford upon Avon) or swap with cash either way for something nice (500W ish) with less physical presence. :-) Willing to split £200 or the cab, £400 for the RPM/APM/Case and pedals.. Go-on, you know you can't resist :-) Marketing Guff below.. Ashdown RPM-1 Pre-Amp. For those wishing to configure their own rack-mounting bass rigs, the Ashdown RPM-1 EVO II preamp puts all the ABM facilities in a convenient rack-mounting package. Three straightforward rotary tone controls provide 20dB of cut and boost at 60Hz, 660Hz and 5kHz, and are supplemented by two pairs of additional sliders giving 15dB cut and boost at 180Hz, 340Hz, 1.3kHz and 2.6kHz. The EQ can be switched in/out, and flat/shaped by footswitch, enabling players to go from a flat fretless sound to a boosted sound via a favourite EQ setting. A single input is switchable for passive and active instruments with a blend of solid state and dual triode tube preamps stages which can be preset and selected by footswitch, providing access to a massive range of clean, warm and overdriven tones. Also footswitchable is the mighty Ashdown sub-harmonic generator which precisely tracks the main signal and reproduces it an octave lower. A sub-harmonic level control enables the player to add just the right amount of low-end reinforcement - everything from a subtle, thickening of the sound to unbridled, bone crushing tone. The ABM RPM-1 EVO II features a balanced DI out with pre or post EQ switching, a sub-bass output, a tuner output, an FX loop and a line input for the connection of an external sampler or sound source. Output muting cuts the signal from the DI output but leaves the tuner output 'live', allowing the player to tune up in silence. The addition of a high-precision crossover with variable frequency from 35Hz to 160Hz and a level control for the low-pass output, enables the configuration of sophisticated bi-amped systems, in which the bass and mid/high frequencies are amplified separately. Ashdown APM-1000 The perfect partner for the RPM-1 preamp, Ashdown's APM 1000 EVO II is a 2 x 500 Watts RMS power amplifier combining simple, elegant design with uncompromising component selection and intelligent quad fan-cooling to achieve exceptional levels of fidelity and reliability, along with low noise and distortion. Each channel has its own massive toroidal transformer ensuring that power delivery is fast and abundant, with high quality output devices delivering a frequency response extending up to 50kHz. Warwick Terminator The Warwick Terminator features 2 Eminence 10" speakers + horn in it's own vented cab and 2 Eminence 15" speakers in a bandpass system. It has two speakon inputs and is carpet covered. It has both fullrange and biamp options, in fullrange mode a 300hz hi pass filter will stop the low frequencies from going to the 2x10 section. In Bi-amp mode, one speakon will be high input at 8 ohm and the other is low input at 4 ohm or 16 ohm which is switchable with the high/low switch. A chrome 3/4" horn in the upper cab with a attentuator at the back completes the cab. Made in Germany Frequency Response: (-3dB) 45 - 15k Low Frequency: (-10dB) 35 Hz Sensitivity: (1W/1M) 99 dB Full-range Impedance: 3/6 ohms switchable MAX SPL: 125 dB X-over (horn high pass) 4, 5 kHz 10s high pass 300Hz Switches for biamp/fullrange mode Impedance switch. 2x15" Speakers Bandpass System= 600Watts RMS 2x10" Speakers + HF Horn = 400Watts RMS D: 37.2 x 23.8 x 19 in. 945 x 605 x 485 mm (HxWxD) 59Kg Edited December 30, 2010 by markstuk Link to comment Share on other sites More sharing options...
markstuk Posted December 17, 2010 Author Share Posted December 17, 2010 Friday night bump... Link to comment Share on other sites More sharing options...
MythSte Posted December 17, 2010 Share Posted December 17, 2010 wowzers...! Link to comment Share on other sites More sharing options...
markstuk Posted December 17, 2010 Author Share Posted December 17, 2010 All PM's replied to.... Link to comment Share on other sites More sharing options...
markstuk Posted December 18, 2010 Author Share Posted December 18, 2010 Snowy Saturday bumpity bump. Link to comment Share on other sites More sharing options...
markstuk Posted December 20, 2010 Author Share Posted December 20, 2010 Snowy Monday bump.. Everyone should have one of these rigs once in their life :-) Link to comment Share on other sites More sharing options...
markstuk Posted December 22, 2010 Author Share Posted December 22, 2010 Wednesday bump - will split - see amended listing.. Link to comment Share on other sites More sharing options...
markstuk Posted December 24, 2010 Author Share Posted December 24, 2010 Christmas Eve Bumpp.. Merry Christmas to eveyone .. Ho Ho Ho... Link to comment Share on other sites More sharing options...
markstuk Posted December 29, 2010 Author Share Posted December 29, 2010 Approaching new Year Bump - this rig was close to three grand new.... Link to comment Share on other sites More sharing options...
Recommended Posts