Jump to content
Why become a member? ×

Samson Airline AP1B Bass Wireless with AG1 Transmitter


Recommended Posts

[i]*SOLD - PENDING PAYMENT*[/i][b][/b]

[size=3][color="#0000FF"]Selling this as I have no real use for it - I never stray too far away from my amp! :)

Its in good condition, works fine, never had any issues or problems with it & sounds OK.

Here's some blurp on it, which I've lifted from another website: [/color][/size]

[i]The Samson Airline AP1B UHF Bass Guitar System eliminates body packs with a tiny micro transmitter that plugs right into the bass guitar.

The Samson Airline AP1B system’s receiver is designed to easily integrate into an effect pedal setup and features a shape circuitry yielding a fat bottom end and fullness never before heard in a wireless system for bass.

The revolutionary AirLine "plug-in" AG1 transmitter comes is designed for traditional end-mount inputs. Less than half the size of conventional body packs, this miniaturized transmitter runs on a tiny triple-A battery with 14-hours of battery life. It features an array of on-board controls: A Power On/Off and Mute switch, red/green LED for Power On/Off, a Peak LED and an Input Level control for different pickups. And UHF (Ultra High Frequency) means clearer frequencies with less interference.

Designed for use with your compact effect pedals, the APB1 pedal receiver gives you reception you can always depend on. It features a 1/4" output jack, Power switch, Peak LED and a Volume control. You can use a 9 volt battery or an AC adapter to power the receiver. When you unplug your the unit, the battery is disabled to conserve power.

Samson Airline AP1B main features include:
Transmitter RF Output Power (5mW): -4dB Minimum, +3dB Maximum
Frequency Stability: -40kHz Minimum, 40kHz Maximum
Modulation Factor: 13kHz Minimum, 15kHz Typical, 17kHz Maximum, Input 1kHz-10dBv
Maximum Input Level: +2 dBv
Input Impedance: 2K ohms
THD: < 2% (1 kHz deviation 15kHz)
Current Consumption: 60mA Typical
Battery Life: 14 Hours (AAA size battery)
Antenna: Permanently attached 1/4 wave length wire
Controls: Power Switch, 15 dB Pad Switch
Indicators: Power On (LED Flash), Low Battery (LED On when battery less than 1.1V)
Type of Reception: Single superheterodyne
OSC (Oscillator) System: Crystal controlled OSC (oscillator)
Intermediate Frequency: 10.7 MHz
Operating Distance: 100m (328 ft) receiver in sight
Noise Reduction: Compander type
Power Input Jack: 5.5mm/.21in diameter
Receiving Sensitivity: More than S/N60 dB (less than 2%) at 21 dBuv input
Squelch Sensitivity: 17dBuv ?4dBuv
S/N Ratio (when comparing to S=0dBv): More than 95dB (IHF-A)
Audio Output Level at div. f15 kHz: Unbalanced output 0dBv
Maximum Output Level: Audio OUT +8dBv ?3dB at 3% distortion div. f36kHz
Audio Frequency Response: 50Hz - 15kHz (at -30dBv ?4dB output)
THD (at SG output 56 dBuv): Less than 1% (at div. f20kHz AF 1 kHz)
Power: AC adapter (12DVC/more than 200mA) or 9 V battery
Peak LED Lighting div. frequency: Div. f23kHz ?3kHz (at AF output approx. +7dBv)
Controls: Audio level volume (front), Squelch level volume (rear)
2-color LED x 2: Power On (Green) / Batt (Red) + TX (Green) / Peak (Red)[/i]



[b]£60 ono (inc. P&P)[/b]

Please PM me; if interested, further info, offers etc...

Thanks

Edited by nick
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...