WITHDRAWN

[Skezza]

Hi

Im looking to replace the 8 ohm speaker in a Bill Fitmaurice Jack 10 enclosure with a 4 ohm speaker

I cannot seem to find a 4 ohm 10 inch bass speaker which must be at least 200 watts (preferably 400 watts)

any suggestions of something suitable

skez

Edited December 19, 2011 by Skezza

[Bill Fitzmaurice]

[quote name='Skezza' timestamp='1324136143' post='1471193']
Hi

Im looking to replace the 8 ohm speaker in a Bill Fitmaurice Jack 10 enclosure with a 4 ohm speaker

I cannot seem to find a 4 ohm 10 inch bass speaker which must be at least 200 watts (preferably 400 watts)

any suggestions of something suitable

skez
[/quote]Like all cabs the J10 requires specific driver T/S specs. And watts don't matter, xmax does. And, unless you have a valve amp that requires a 4 ohm cab, there is no benefit to changing the driver,

[Skezza]

Thanks I did not realise that the cabs used a specific driver I bought it secondhand the driver thats in is an Emminece beta 10a which i am pretty sure is 250 watts into 8ohms I was going to use it with my 4 ohm 1 x15 is that ok

I use an old peavey Tmax head which will go down to 2 ohms


skez

[Bill Fitzmaurice]

[quote name='Skezza' timestamp='1324137485' post='1471208']
Thanks I did not realise that the cabs used a specific driver I bought it secondhand the driver thats in is an Emminece beta 10a which i am pretty sure is 250 watts into 8ohms I was going to use it with my 4 ohm 1 x15 is that ok


[/quote]Never mix cabs. Most especially never mix horn loaded cabs with direct radiators.