steve-bbb Posted May 1, 2012 Share Posted May 1, 2012 (edited) no name no brand no idea - maple one piece with rosewood board - dot inlays on fretboard and dot inlays on side bought it on here about 6 months ago for my build which has now dematerialised bought it on here for thirthy will let it go for same (so essentially 25 + 5 p&p) no offers no swaps ta (will find the original thread laters and post it with a pic or two) Edited May 1, 2012 by steve-bbb Link to comment Share on other sites More sharing options...
steve-bbb Posted May 1, 2012 Author Share Posted May 1, 2012 will check it and post later - thanks Link to comment Share on other sites More sharing options...
steve-bbb Posted May 1, 2012 Author Share Posted May 1, 2012 (edited) this is a scanned image - is actual size at 600dpi so if you print it out without any size adjustment you should be able to measure from it pic direct link is [url="http://bigblueballoon.net/p-neck.jpg"]http://bigblueballoon.net/p-neck.jpg[/url] edit- have removed pic embed as i think the size was causing browser issues Edited May 4, 2012 by steve-bbb Link to comment Share on other sites More sharing options...
steve-bbb Posted May 2, 2012 Author Share Posted May 2, 2012 bump the measurements were taken from the scanned image not from me holding a ruler or tape against the item btw (which i would argue with my cad/illustrator knowledge is more accurate than eyeballing a measuremnt with a ruler! but nonetheless still open to 'interpretation' as to where you place your start and end points for measuring - if you print the image you should have an accurate 1:1 scale to be able to take measurement from) Link to comment Share on other sites More sharing options...
steve-bbb Posted May 4, 2012 Author Share Posted May 4, 2012 bump Link to comment Share on other sites More sharing options...
Recommended Posts