Jump to content
Why become a member? ×

SOLD: Hartke HX112's + LH500


Recommended Posts

I'm looking to downsize for when i sell my car and will be using the tube and buses for transport :o

So up for grabs are my Hartke HX112's and LH500.

Ideally i would like to trade for a Mark Bass NY121 and Little Mark II however, i will consider similar setups.

If a trade doesn't occur i will sell. I would like to sell it as a rig or split to head+cab. I don't want to sell the head unless i've sold a cab as then i would have two cabs and nothing to play through. Money wise i would like £230 per cab and £220 for the head or £620 for the total rig (£220 per cab and £180 for head) or £410 for 1 cab and the head (220 cab and 190 head).

Here are the specs for the cabs. They are in good condition with a few light scratches/ marks.
[list]
[*]1 x 12-inch 300 watt HyDrive neodymium hybrid cone driver
[*]1-inch titanium compression driver
[*]Power Handling: 300 watts
[*]Ported Cabinet
[*]Impedance: Switchable between 4 and 8 ohms
[*]Frequency Response: 41 Hz to 17 kHz
[*]Sensitivity: 96 dB @ 1 W/1 m
[*]Voice Coil: 2.5"
[*]Parallel Speakon® and 1/4" inputs
[*]High Frequency attenuation switch (On, -6 dB, Off)
[*]Dimensions: 19"(H) x 15"(W) x 16"(D)
[*]Weight: 30.4 lbs
[/list]
And the Head. Again in good condition with a few small scratches.
[list]
[*]500 watts of power @ 4 ohms
[*]Classic 12AX7 High Voltage Class-A tube preamp circuit
[*]Bass and Treble Shelving, plus mid-peak EQ controls
[*]Selectable brite switch for added high frequency response
[*]Selectable limiter switch with LED indicator
[*]Front panel XLR balanced direct output
[*]Rear panel 1/4-inch effects loop
[*]1/4-inch output connectors
[*]Two-rackspace metal chassis with steel faceplate and handles
[/list]

Edited by OliverBlackman
Link to comment
Share on other sites

[quote name='chris_b' timestamp='1338997862' post='1682174']
There's only a 1lb difference between your cab and the Markbass cab!!

I'd keep your rig and get a trolley.
[/quote]

Im going to get a trolley i think anyway but theres a few reasons i'm looking to swap. 1) I've been using hartke hydride for 4 and a bit years now and i fancy a change. 2) Not only are there a few dimension differences in the cab but i also will need a small lightweight head to carry separately. This is why I'm thinking of the little mark. If i can only sell one cab and the head then i will get a lightweight head for the Hartke cab, but i like to keep my rig matching :)

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...