Signal blending with the Behringer AB100

[rushers]

So most of you will be familiar with blending a dry and wet signal with the Boss LS-2 and I recently realised I had a Behringer AB100 kicking around and I was wondering if I could do the infamous signal blend with this pedal.

http://www.behringer.com/EN/Products/AB100.aspx

Perhaps I'm just being dim but I can't work out a signal chain where I could blend two signals, it's likely that I can't have the two channels playing at the same time as I suppose it is a Line selector.

I tried
Bass > Tuner bypass > input A
Effects > input B

Which didn't really work, I could only switch between effected and clean.

Anyway, excuse me if I'm being dim, any thoughts?

Edited August 17, 2012 by rushers

[EskimoBassist]

If you had TWO you could do this.

You set one to In 1, Out A Out B (and run your effects through A for example and leave B empty) and then run the second as In 1 In 2, Out A.

Thus you split your chain into A and B, with A effected and B clean, and then recombine it into one signal. You'd then use the level controls to change the wet/dry mix.

Basically it would be much easier to buy an LS-2 and use one of the mixing modes or a dedicated blender pedal (lots available on the market) than it would be to use these as obviously this method requires two pedals, not one.