Jump to content
Why become a member? ×

EA Micro 550 with padded bag and DI cable * SOLD *
£390


Recommended Posts

Posted (edited)

My gear downsizing continues. I bought this from the forum a few months back at £400 and have since added a DI extension lead (as the head does not have an XLR out) and a neat padded bag (not EA but fits perfectly), together costing about £35. Will sell for £390 posted (£380 collected) which is a bargain for an amp of this quality and in basically near-perfect condition (they are £550 new at BassDirect and the XLR conversion cable is £14 on top).

Works fabulously for double bass (has two channels, one specifically voiced for piezo input) but I've also used it with my fretless acoustic/electric bass and its both loud and ludicrously light.

Stock pic (mine looks identical):
[attachment=136694:EAmiucro1200.jpg]

Specs:

Inputs: Configuration: 2 independent channels- Channel 1 Mid EQ set at 500Hz for electric bass, Channel 2 Mid EQ set at 800Hz for upright/acoustic bass

•Input Impedance: 1Meg ohm input impedance on both inputs
•Trim controls: Independent channel level adjustments, DI output level, and high pass filter
•Intelligent Input Switching: Select different settings for 1 bass or have independent setups for 2 basses, Channel 1 or Channel 2, or Channel 1+2
•Controls: Channel switch, Input gain, 3-Band EQ, Master Volume, Mute switch, Effects loop blend
•EQ: Low, Mid, and High for each channel, Variable high pass filter 22-80 Hz, 6db per octave (allows selection of a frequency below which response is reduced, helps boomy rooms and stages-Channel 2 only)
•Effects Loop: Parallel effects loop with blend control, wide range of setups via internal jumpers
•Outputs: Speakon speaker, tuner, effects send, balanced DI out (1/4" stereo wired as TRS)
•Protection: Internal cooling fan, thermal and overload
•Line Voltage: 100/120 - 240 volts internally selected via jumper
•Frequency Response: 20Hz to 20kHz +/- 3dB
•Power Output: 550 watts @ 4 ohms 310 watts @ 8 ohms
•Size: 2.1"H x 8.5"W x 5.4"D
•Weight: 2.3 lbs.

Edited by Clarky
  • 2 weeks later...
Posted

Cheers Tom and it looks virtually brand new too. I am surprised it hasn't been snapped up but then again the same applies to loads of other good stuff for sale on BC

Posted

Bump. Hard to find anything as tiny as this with as much power - 2.3 pounds delivering 550W of clean, quality amplification

Posted

Sorry but in answer to a couple of PMs this is sale only. I already have too many amps (four) which is why this lovely piece of kit is for sale!

Posted (edited)

Addendum - I include £10 postage cost within UK. Post to mainland Europe would be about £20-25, ie, all-in cost about £390-395 to France/Germany/Belgium etc depending on fast or economy service

Edited by Clarky
Posted

[quote name='paddy109' timestamp='1372283221' post='2123932']
Super amp bump
[/quote]Thank you! Tis indeed a super amp but EA's seem to attract a small minority of BC's community

Posted

Hi there, its a little trim pot on the top edge (you would need a fine screwdriver to adjust it). I have to say I've never touched it. Here's the manual [url="http://eaamps.com/UploadedPDFs/micro%20doubler%20manual%20hi%20res.pdf"]http://eaamps.com/UploadedPDFs/micro%20doubler%20manual%20hi%20res.pdf[/url]

Posted

Clarky - I had the "discussion" with my wife about keeping my old ea micro for a backup when my new one comes but apparently we have a "one in one out" rule on bass amps! Pah - have you ever heard anything so ridiculous?
Good luck with selling the little miracle.

  • 3 weeks later...
Posted

Interesting, especially considering I'm about to get an EUB.

Out of interest, what cab did you partner this with for double bass ?

Posted (edited)

Hi there, I had it paired with an Epifani UL112 for gigs or a Crazy8 (custom 1x8) cab for rehearsals and very small gigs. No reason why it couldn't be paired with any quality cab though.

Edited by Clarky
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...