Jump to content
Why become a member? ×

Refretting a defretted neck - any point? hard?


Paul S
 Share

Recommended Posts

I bought a defretted neck from a VM Squier Jazz and the defret was - trying to put it politely but can't really - total sh*te. Not really useable as a fretless, tbh. Cosmetically it wasn't helped by me heavy-handedly using a heat gun to get rid of the paint finish on the headstock and leaving a nice charred mark on it. Nevertheless the neck seems straight, truss rod works.

Is there any point in somehow removing the filler from the fret lines and getting it refretted? is this an expensive job to get done at a luthier or, indeed, a difficult to do myself?

Or, another option, remove the filler then re-do it so that the neck is actually flat and useable? There is a fair bit of splintering and missing bits of the rosewood, so the lines are not crisp - how well would it stain?

Or is it best to just bin it and save myself a lot of fiddling about?

Link to comment
Share on other sites

With a small handsaw it might be possible to chase out the original fret slots. Depending on how wide the slots are, you can find some flat plastic sheeting of some kind to superglue in to keep the fingerboard stable. Old credit cards and ice cream containers have been used in the past. Then just plane and then sand with a radiussed block.

Link to comment
Share on other sites

I have a related but slighty different question - I'm thinking of frettting a fretless that was supplied with brass 'fret' markers. Any thoughs on the best way to get the markers out?

I am assuming that the brass would be harder than the rosewood of the fretboard, so a saw would wander. and I do not think I can use a soldering iron to expnd the metal to widen the groove so that it can be got out more easily - it would burn the wood.

The only thing I have come up with so far is to grind down a Stanley knife blade and use that with a hammer to tap out each fret marker. A ground-down single-sided razor blade might be better, but I am not sure if you can still get them.

Any comments welcomed.

David

Link to comment
Share on other sites

[quote name='Mottlefeeder' timestamp='1378053221' post='2195160']

I am assuming that the brass would be harder than the rosewood of the fretboard, so a saw would wander. and I do not think I can use a soldering iron to expnd the metal to widen the groove so that it can be got out more easily - it would burn the wood.
[/quote]

You mit get away with an adjustable temperature iron somthat it wouldn't run quite so hot, could twke a while though.

Edited by paul_5
Link to comment
Share on other sites

I refretted the neck on my Warwick (it was very very cheap and already a bit battered) that I defretted a couple of years ago.

The hardest bit is profiling the ends of the frets and not lacerating your fingers becuse you've done a bodged job :blush:

I got proper Warwick fret wire from Banzai music.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...