Marshall VBA400 400W Valve Amplifier Head NOW SOLD £750

[Violetbass]

Please send me a message if interested! Thanks, Tim

* Fully serviced including installation of 8 new Marshall 6550 output valves (cost £180)
* DC bias, DC bias balance and AC balance of the output stage have all been set correctly
* all pots, inputs, outputs, DI, FX loop tested and working - no crackles or hums
* all spade terminals and ribbon cables checked for dry joints and intermittent contact
* all valve bases and pots cleaned
* all 8 10" drivers working without rubbing or breakup
* Achieves full 400 W output power into 2 and 4 ohm loads
* PAT safety tested
* comes with high quality 1m VDC speaker cable with Neutrik jacks, and IEC cable
* [b]comes with 1 year labour (not parts) warranty[/b] - if anything goes wrong I'll fix free of charge, providing it has not been mistreated or neglected. You would have to return the item to me at your cost and be prepared to accept a 2-3 week turnaround time. Call to discuss further if interested: 07773 310087
Condition of the head is 9/10 - nothing serious at all, and certainly no big rips or dings.
For the cabinet I'd say 8/10 - again, nothing major, some small scuffs on the sides. The grille cloth is in good condition with no rips. Both Marshall logos are intact. 2 new rubber feet have been installed on the rear. Castors are smooth and the rubber is not worn.
This is collection only from Hampton Wick, London. I can deliver around London for a mutually agreeable amount, or anywhere reasonably close to the M40 up to and including Junction 15.

Edited March 12, 2014 by Violetbass

[doctorbass]

PM sent

[badboy1984]

If my back wasn't sore and i have some muscles i think this would be good for me lol. I've try lift the head on my own and i couldn't even carry the thing.

[Sibass11]

I Had one of these with two 4x12 cabs!! It was fantastic!!

[Violetbass]

Thanks to all who viewed or expressed an interest - this rig is now SOLD.

Tim