Dave_the_bass Posted August 1, 2014 Share Posted August 1, 2014 [quote name='Grissle' timestamp='1405954525' post='2506882'] If the amp only has valves in the preamp however you can generally treat it like any other SS amp. Anyway I'm not aware of any amps with non-valve power sections that require a speaker load? [/quote] Ashdown mag amps employ a switched jack speaker output. No jack in any speaker socket presents a dead short (or 0 ohm impedance load) across the output transistors. They'll get very hot and melty very quickly! Quote Link to comment Share on other sites More sharing options...
gsgbass Posted September 4, 2014 Share Posted September 4, 2014 This little dude always has a main speaker out plugged in before anything starts up. [IMG]http://i.imgur.com/3gOn1V9.jpg[/IMG] Quote Link to comment Share on other sites More sharing options...
Guest monsterthompson Posted September 4, 2014 Share Posted September 4, 2014 [quote name='Billy Apple' timestamp='1405852604' post='2505725'] A valve amp must be connected to a load or you risk damage to the power section of the amp. The load is usually the speaker, but you can get dummy loads for DI'ing in a studio or to work on the amp. Always remember to have to right selection of [u][b]ohmage[/b][/u] on the head for the speaker [/quote] Quote Link to comment Share on other sites More sharing options...
Guest monsterthompson Posted September 4, 2014 Share Posted September 4, 2014 (edited) [url="http://www.mesaboogie.com/Product_Info/Bass_Amps/prodigy/bassProdigy.html#gpm1_2"]http://www.mesaboogi...igy.html#gpm1_2[/url] Mesa will let you run the valve Prodigy without a load IF you flip the right switch. I believe my Buster also has similar technology, though the manual still suggests keeping a speaker connected (on the off chance somebody bumps the switch by mistake). The M6 and Walkabout (solid state power sections) have instruction manuals saying to never run them without a load. Mesa Hollywood employees and techs will tell you the same. I've run my WA without a load for recording silently, and it worked fine. I know others state the same. I'd say it is always wise to have a load connected. However, there are exceptions to that rule. Edited September 4, 2014 by monsterthompson Quote Link to comment Share on other sites More sharing options...
Bill Fitzmaurice Posted September 4, 2014 Share Posted September 4, 2014 (edited) [quote name='mart3442' timestamp='1406894967' post='2515679'] I'll tell that to my friend with the fried amp...... [/quote]His amp may be fried, but it had nothing to do with the lack of the speaker. When in standby mode there is no current flowing to the tube plates. That's why no sound comes from the amp when in standby. If there's no current there's no potential for damage. He might as well have claimed that he blew the engine in his car by pressing the gas pedal to the floor...whilst the ignition was off. Edited September 4, 2014 by Bill Fitzmaurice Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.