Eminence Basslite S2010s into rumble combo.

[Freddie75]

Hi all,

Has anybody on here upgraded the stock drivers in the fender rumble combos and were the results any good? I have the v3 500 combo and have read this upgrade makes a big difference.

Also, do these drivers slot straight in or would any mods to cab need to be made?

Thanks
Freddie

Edited May 14, 2015 by Freddie75

[Mykesbass]

Do they do 16 ohm versions?

[Freddie75]

Good point, can't see that they do. To add 2 8ohm drivers making the cab 4ohm I'm assuming would require some mods to the bracing of the cab?

Thanks
Freddie

[Merton]

[quote name='Freddie75' timestamp='1431702877' post='2774150']
Good point, can't see that they do. To add 2 8ohm drivers making the cab 4ohm I'm assuming would require some mods to the bracing of the cab?

Thanks
Freddie
[/quote]

Why would an impedance change require bracing modification?

[RandomBass]

If they make them in 4 ohm then you can wire them in series. If they are just 8 ohm only then wire them in parallel for a 4 ohm total impedance. You wont be able to use an extension cab after that. I doubt extra bracing will be required.
I'm sure the experts will be able to advise here.
Cheers
Geoff

[Freddie75]

Thanks for advice this far guys. I just assumed that if changing to 4ohm which would then draw full power from the amp it might need some kind of mod to bracing. I'll shut up now - obviously a novice at this! :-)