Jump to content
Why become a member? ×

How to connect pre-amp to amp?


SgtD
 Share

Recommended Posts

The Genz is twin channel,tube and fet. Been running the pre amp through the effects loop,clean to the tube and overdrive to the fet but I'm getting quite a bit of white noise and what sounds like an earthing problem but this does not happen when I connect only one channel at a time. I'll try the preamp out to the power amp in and see what happens but that is in the master section of the effects loop which feeds the signal to both the tube and fet at the same time. How do I go about running the overdrive channel on the bsp back through the clean effects loop on the bsp?

Thanks for reply

Chris/SgtD

Link to comment
Share on other sites

Never seen the back of a power amp link that... A more usual set would be a poweramp in and a preamp out. I'd just try each and see that sounds best. If you think there's an earthing issue, get that sorted.

Regarding the bsp, isn't there a blend control anyway?

The clean output is marked mix.

If you've got two cabs, is it worth trying using both channels? One clean, one overdriven?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...