Another Artec Question :-)

[kodiakblair]

I've stuck the Artec SE-2 in another bass but encounter a strange problem.

The volume pot doesn't work, the bass plays and the blend works fine but I can't turn down the volume.
Any ideas folks ? Wasn't the best solder joint on the volume ground, could that be the issue ?

Cheers KB

[Thunderbird]

Might be be but I would of thought if it was a bad ground it would not work at all or be very crackly and intermittent I think it is a bad pot mate

[kodiakblair]

[quote name='Thunderbird' timestamp='1493492729' post='3288799']
Might be be but I would of thought if it was a bad ground it would not work at all or be very crackly and intermittent I think it is a bad pot mate
[/quote]
I think I'll take that a stage further an say the whole thing is shot Volume pot don't respond nor do either of the tone pots. Blend seems to be acting like a volume pot,roll it back and I'm getting almost zero volume. Go past the centre dent an I'm jumping to turn the amp down

Edited April 29, 2017 by kodiakblair

[Thunderbird]

Send it back send it back lol

[kodiakblair]

Too late brother. 2nd bass it's been in