Jus Lukin Posted October 4, 2017 Share Posted October 4, 2017 (edited) - Edited February 25, 2022 by Jus Lukin Quote Link to comment Share on other sites More sharing options...
ikay Posted October 4, 2017 Share Posted October 4, 2017 (edited) Looking at the blue high pass line on the Linkwitz-Riley freq chart below, if the cutoff freq ('fo') is 30hz then I'd estimate the corner freq to be around 40hz. So this should give you what you're after. Edited October 4, 2017 by ikay Quote Link to comment Share on other sites More sharing options...
Chienmortbb Posted October 7, 2017 Share Posted October 7, 2017 You probably won't notice the "loss" if the turnover is 40 Hz. Despite the fundamental of the Low B string, has most of its energy at 62Hz and above. Quote Link to comment Share on other sites More sharing options...
Jus Lukin Posted October 9, 2017 Author Share Posted October 9, 2017 (edited) - Edited March 1, 2022 by Jus Lukin Quote Link to comment Share on other sites More sharing options...
ikay Posted October 9, 2017 Share Posted October 9, 2017 [quote name='Jus Lukin' timestamp='1507553943' post='3386280'] If 2fo is 60hz then the corner does look to be at about 40hz. [/quote] Yes, 2fo is an octave up from the cut off frequency. Quote Link to comment Share on other sites More sharing options...
Phil Starr Posted October 14, 2017 Share Posted October 14, 2017 As someone who has been playing around with speaker design for quite a while I have a kind of rule of thumb which helps me predict what small changes in design will actually sound like in practice. A 1dB change in frequency response is just audible in an A/B test wher you have both systems (speakers in this case) next to each other and can switch quickly between the two. 3dB is generally noticeable anyway, you'd hear a difference in bass output between two speakers with a 3dB difference at 60Hz. Below that our ears are not very sensitive, at 30Hz I don't think anyone with an untrained ear would detect any difference that couldn't be fooled in a blind test. Of course 3dB is half the power so you are significantly reducing the demands you make on the speaker if you filter out the lows. If you use a ported speaker there are two vulnerabilities around the tuning frequencies. Wind noise in the port at the tuning frequency and uncontrolled and excessive excursion below the tuning frequency. Most bass cabs are tuned fairly close to 50Hz so a 3dB cut below this can only be a good thing and unlikely to be audible. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.