Audere Low Z switch

[Owen]

I have an Audere pre which is not voiced correctly for what I want it to do with a specific pick up (no fault of the pre-amp, it is a nice bit of kit) but I LOVE what the Low Z switch does. Is there any other way of getting this particular attribute going?

Thanks

Owen

[Hamster]

[quote name='owen' post='324713' date='Nov 8 2008, 10:42 AM']I have an Audere pre which is not voiced correctly for what I want it to do with a specific pick up (no fault of the pre-amp, it is a nice bit of kit) but I LOVE what the Low Z switch does. Is there any other way of getting this particular attribute going?

Thanks

Owen[/quote]

There are very tiny trim pots on the pre-amp PCB that adjusts the sweep on each of the tone pots. Not sure if you can adjust the impedence with a trim pot though? - Shoot a mail off to Dave Meadows at Audere - he's very helpful

[Owen]

[quote name='Hamster' post='324733' date='Nov 8 2008, 11:32 AM']There are very tiny trim pots on the pre-amp PCB that adjusts the sweep on each of the tone pots. Not sure if you can adjust the impedence with a trim pot though? - Shoot a mail off to Dave Meadows at Audere - he's very helpful [/quote]


Thanks. Hmmm........ I might re voice it then

I doubt Dave is going to tell me the secret of his variable Z switch as all I want to do (when I say I, I mean a friend who can actually use a soldering iron without smelling burning flesh) is bodge up a switch which will do the same thing.