Glockenklang BassArt + Bugatti 120 - ON HOLD !! £1050

[funkydario]

I am playing only in-ear monitor lately so the "beast" need To go. Recently cleaned up and change the speaker out with speakon. The preamp do not need presentation and the pwr amp pump out 240w/8 ohm bridged...very loud.

I am asking 1200€ shipped.

 

Edited July 2, 2018 by funkydario

[funkydario]

Bump and serious offer considered.

[Jaco Pastasciutta]

Very Nice !

[funkydario]

Will accept partial trade with Line6 Helix Floor with bag  (eventually ) and Line6 G70. 

[sifi2112]

How do you ‘bridge’ the two channels ?

[Dad3353]

1 hour ago, sifi2112 said:

How do you ‘bridge’ the two channels ?

From the manual...

...

5.1 Mono Bridged Mode In bridged mode use the left XLR-female input and connect the XLR-male beneath it with a crosscable to the XLR-female input of the other channel. At the crosscable pins 2 and 3 at the male plug are changed to 3 and 2 of the female plug, which results in a phase switching at the second channel. The speaker is connected to the red binding posts, whereas the speaker+ is at the left channels post and the speaker – at the right channels post. Both black binding posts have to be connected by a 4 qmm cable.Attention: In bridged mode the minimum impedance is 8 ohms!
...

Having no binding posts, a suitable-cabled 'bridge-mode' Speakon cable would have to be used with this model.
Hope this helps.

[sifi2112]

Not quite sure if a standard male to female xlr bridges the preamp ..?

And regarding the speakon outs, do they need a Y split speaker cable with just the ‘+’ wired on both left & right channel speakon out then going to standard ‘+/-‘ speakon to 8 Ohm cab ..?

[Dad3353]

3 hours ago, sifi2112 said:

Not quite sure if a standard male to female xlr bridges the preamp ..?...

No, it's a crosscable that's required...

...the crosscable pins 2 and 3 at the male plug are changed to 3 and 2 of the female plug, which results in a phase switching at the second channel...

3 hours ago, sifi2112 said:

...a Y split speaker cable with just the ‘+’ wired on both left & right channel speakon out then going to standard ‘+/-‘ speakon to 8 Ohm cab ..?

That is correct.

[funkydario]

Sorry for late answer , I was out town and thanx to Dad3353 for filling in !! Anyway the XLR cable to connect to power amp and to bridge it it's included.

Edited June 24, 2018 by funkydario

[Dad3353]