Painting a Pedaltrain

[danpb]

Has anyone else painted a Pedaltrain board before?

Here's my first attempt.

Didn't remove the black finish, just gave it a key with a fine sanding sponge. 5 thin coats of  nitro, then a couple of coats of clear poly I had. The only pain was having to drill out the rivets on the feet, then tapping the hole to create a thread to screw them back on.

Turned out pretty well

Edited May 16, 2018 by danpb

[Al Krow]

Nice!

Edited May 16, 2018 by Al Krow

[Microbass]

Snazzy! 

[Twigman]

13 hours ago, danpb said:

The only pain was having to drill out the rivets on the feet, then tapping the hole to create a threat to screw them back on.

When i drilled mine off I replaced the rivets with jacknuts so I could screw on longer rubber feet to provide clearance for a TRex underneath.

Worked a treat and far easier than tapping the hole.

[danpb]

I considered that,  but as I use the Volto, I'm all good for ground clearance. I already had a set of taps too so it wasn't any extra effort. 

[CameronJ]

Nice job! That’s given me ideas about hydro-printing patterns onto Pedaltrains now...