danpb Posted May 15, 2018 Share Posted May 15, 2018 (edited) Has anyone else painted a Pedaltrain board before? Here's my first attempt. Didn't remove the black finish, just gave it a key with a fine sanding sponge. 5 thin coats of nitro, then a couple of coats of clear poly I had. The only pain was having to drill out the rivets on the feet, then tapping the hole to create a thread to screw them back on. Turned out pretty well Edited May 16, 2018 by danpb 1 Quote Link to comment Share on other sites More sharing options...
Al Krow Posted May 15, 2018 Share Posted May 15, 2018 (edited) Nice! Edited May 16, 2018 by Al Krow Quote Link to comment Share on other sites More sharing options...
Microbass Posted May 16, 2018 Share Posted May 16, 2018 Snazzy! Quote Link to comment Share on other sites More sharing options...
Twigman Posted May 16, 2018 Share Posted May 16, 2018 13 hours ago, danpb said: The only pain was having to drill out the rivets on the feet, then tapping the hole to create a threat to screw them back on. When i drilled mine off I replaced the rivets with jacknuts so I could screw on longer rubber feet to provide clearance for a TRex underneath. Worked a treat and far easier than tapping the hole. Quote Link to comment Share on other sites More sharing options...
danpb Posted May 16, 2018 Author Share Posted May 16, 2018 I considered that, but as I use the Volto, I'm all good for ground clearance. I already had a set of taps too so it wasn't any extra effort. Quote Link to comment Share on other sites More sharing options...
CameronJ Posted May 16, 2018 Share Posted May 16, 2018 Nice job! That’s given me ideas about hydro-printing patterns onto Pedaltrains now... Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.