Help Identifying grub screw

[Joebass]

Hi,

Can anyone help me find a suitable replacement for these grub screws? One of the heads is completely rounded and I can't adjust it.
They're from a Mayones Jabba bridge.

Thanks 

[Reggaebass]

Hi do you mean it has no slot 

[KiOgon]

You could file the mangled end clean and cut a new slot with a junior hacksaw and/or a sharp edged needle file. 😎

[Joebass]

It's a hex head. I had been using a 1.5mm allen key to adjust but it's a little small. I tried a 1/16 inch key but that was too big.

[KiOgon]

2 minutes ago, Joebass said:

It was a hex head.

It could easily become be a slothead 😄

Edited July 28, 2018 by KiOgon

[Joebass]

Just now, KiOgon said:

It could easily become be a slothead 😄

😁 True! I may have to do this but ideally, I'd like to get some new screws.  

[Pete1967]

Almost certainly a metric thread, somewhere between M2 and M3, and 12mm in length by the look of it, but I'd contact Mayones to be sure. 

This might be your source

[Joebass]

Thanks, Pete. That's great!

[blablas]

Judging by the (imperial) ruler, M3x10.

1" = 25.4 millimeters.

[Joebass]

Thanks!

 

[MoonBassAlpha]

I'm pretty sure I've got some of these in stainless steel. I could pop a couple in an envelope for you if you'd like. I think I've got 2 lengths, something like 10 and 6mm, very handy for non American Fender style guitar bridges where you don't want the screws tearing your hand up when palm muting. PM me and I'll check when I get home tonight.

[Joebass]

Thanks, MoonBassAlpha. That's very generous!

I've already ordered some so I should be good. 

Cheers,

Joe