mojobass Posted September 5, 2018 Posted September 5, 2018 Project jazz bitsa! Basically I’ve put together what parts I had lying around, it’s not finished as you can see so still requires the following: machineheads, pickguard screws Also, the body has a battery box in the rear. The controls are an old active circuit I had in my spares box which is a mayonnes one, however, after wiring it all up and bench testing it it appears the circuit is caput as it will only work in passive mode! So will need replacing if you desire active electrics! Body is alder, pickups are fender MEX neck pickup with a squire bridge pickup. Neck is tinted maple standard jazz profile 21 fret. Pickguard is generic tort one and the neck pickup route has been widened slightly, but not that noticeable from 10ft away! Anyhow, decent starting point for a nice bass. £90
mojobass Posted September 23, 2018 Author Posted September 23, 2018 Preamp removed so now just body including pickups/bridge/pickguard £45
Marc S Posted November 9, 2018 Posted November 9, 2018 You say the neck pickup rout is wider - is this completely covered by the scratch plate? Hard to see in the photo. Also, would the neck pocket fit a standard Fender neck? Cheers
mojobass Posted November 9, 2018 Author Posted November 9, 2018 Hi, this has been on here so long I’d forgot about it! All that’s left of it now is the body/bridge and a set of squire pups and tort pickguard! Yes the cavity is hidden by pickguard
.jpg.518c69c2d9e1581799f3c11301dc2da5.jpg)
Recommended Posts