Slappindabass Posted September 5, 2019 Posted September 5, 2019 Here Is a Birth Precision Bass, made in Japan? Not sure....various rumours on the net about them being made by Tokai. I however do not think so. It plays ok, could do with a setup, teuss works as it should.
WHUFC BASS Posted September 8, 2019 Posted September 8, 2019 What's the weight and the nut width on this mate?
WHUFC BASS Posted September 8, 2019 Posted September 8, 2019 Thanks mate, any idea on the type of wood that's used? Is it ply ?
Slappindabass Posted September 9, 2019 Author Posted September 9, 2019 No I do not think its Ply. I shall whip it apart tinight and have a look in the pocket. 1
BaggyMan Posted September 9, 2019 Posted September 9, 2019 I'll take it, I am in Rochester will pm you for pickup
Slappindabass Posted September 9, 2019 Author Posted September 9, 2019 Going to withdarw this and use the neck in a project. 1
WHUFC BASS Posted September 9, 2019 Posted September 9, 2019 Nice one. I did a bit of research on these and they are made by Tokai - or at least they were in the early 80s. Anyway, enjoy !
Slappindabass Posted September 9, 2019 Author Posted September 9, 2019 Surprised at tokai Using ply. To be fair As the neck was off, I gave it a set up and a new set of 110 rotos. Sounds thunderous.
WHUFC BASS Posted September 9, 2019 Posted September 9, 2019 I think these were the budget side of the Tokai operation from what I can gather. I think they were only made for the Japanese market
.jpg.2a95db90b70ff3f3317b0f7ee3970acb.jpg)
Recommended Posts