Jump to content
Why become a member? ×

sold:2xARTECSE3:3-band5-potActiveBassEQpre-amp
£32
TS


Recommended Posts

Artec SE3 (band EQ) features a pre-wired balance control and master volume, Bass and treble on separate potentiometers with the mid band control on SMT PCB. I have TWO of these - one fitted briefly; the other as-new (£32.10 incl. for the new one + the 'used' one - see photos, all fittings/connections are fine, just less-than-perfect amount/shape of solder on the solder points). Each control pot designed to connect to PCB by connectors, which make SE3 installation easier. All you have to do is solder connection to pickup, output jack, ground and battery clip* (*included). High Impedance Input design matches with any Active and Passive Pickup. And also Low Impedance Output will keep the same tone from your guitar to any amplifier system without losing high frequency response.. Using advanced Surface Mount Technology could reduce unwanted sounds (Noise) while increasing sound quality and it's reliability. ARTEC guarantees a virtually noiseless sound with long 9 V battery life (more than 2000 hours in continuous use. - workable voltage : drop down to 2.2 V). Technical Specifications : Bass : +/-12 dB at 80 Hz, Middle : +/-12 dB at 800 Hz Treble : +/-12 dB at 4 kHz, Balance : MN500K Potentiometer. Current : 0.32 mA Voltage range : 6 V ~ 22 v Battery : 9 V Alkaline SE3 ....Features : - 5 individual pots - Balance,Treble, Middle, Bass, Volume, - Battery clip

http//www.artecsound.com/pickups/electronics/se3.html  (shows fitting etc.)

MVC-074S.JPG

 

 

 

 

 

 

 

 

Edited by eubassix
error; sold + sold
Link to comment
Share on other sites

  • MB1 locked this topic
Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...