Is this nut ok?

[Radchenko]

Hello,

A luthier made me this nut. Do you think is ok please?.

Is neccesary the lines be straight?

Thank you.

[PaulThePlug]

String slots arn't straight, and the nut looks a little wide... Hope they didn't charge you!

[Thunderbird]

That's terrible I don't think a proper luthier would pass that off I'd take it back mate it looks like it's been done with a dremel as the material is marked and looks rough on the edges almost like melted but it is hard to tell just from the picture

Edited October 6, 2020 by Thunderbird

[BreadBin]

12 minutes ago, PaulThePlug said:

String slots arn't straight, and the nut looks a little wide... Hope they didn't charge you!

Bang on, a very poor effort frankly.

[Reggaebass]

Ola Radchenko, it looks untidy to me, here’s my Sandberg for comparison 🙂

[ezbass]

1 hour ago, Radchenko said:

Hello,

A luthier made me this nut. Do you think is ok please?.

Is neccesary the lines be straight?

Thank you.

That’s a nasty looking bit of work. Your strings are going to catch when tuning, especially on the G.

[Radchenko]

14 minutes ago, ezbass said:

That’s a nasty looking bit of work. Your strings are going to catch when tuning, especially on the G.

Thank you,

Sorry, what is catch?.

Edited October 6, 2020 by Radchenko

[A.G.E.N.T.E.]

That looks a bit of (cheap) plastic, and the work dosen`t look very professional. I know the image is a bit magnified but.. i don`t know if you can call that señor a luthier. I think that depends on the context. Was this charged as low cost and fast solution or as premium service? Nonetheless, that might be a perfectly funcional nut.

[PaulThePlug]

Catch... Stick - not slide when tuning

[Radchenko]

48 minutes ago, A.G.E.N.T.E. said:

That looks a bit of (cheap) plastic, and the work dosen`t look very professional. I know the image is a bit magnified but.. i don`t know if you can call that señor a luthier. I think that depends on the context. Was this charged as low cost and fast solution or as premium service? Nonetheless, that might be a perfectly funcional nut.

Thank you,

Actually is carbono 😞

[Beedster]

Awful, slots not straight, blank too wide for neck so all slots shifted towards treble side with nut overhanging, G and D slots close to same width.

[ezbass]

2 hours ago, Radchenko said:

Thank you,

Sorry, what is catch?.

The windings will stick on the angled slots making tuning troublesome.

[robertg43]

I wouldnt put my name to it

[Beedster]

1 hour ago, robertg43 said:

I wouldnt put my name to it

Unless your name was Mr Rubbish Nut

[Drax]

@Radchenko you don't have much luck with custom builds do you mate?  

 

[Radchenko]

2 hours ago, Drax said:

@Radchenko you don't have much luck with custom builds do you mate?  

 

Trying to fix Adrian fails, still on It. Thank you.

[yorks5stringer]

On 11/10/2020 at 14:48, Radchenko said:

Trying to fix Adrian fails, still on It. Thank you.

Is this what was fitted direct from 'he who cannot be named'? If so, that is very poor but the good thing is it's very easy to fix ( not that you should have to )