weefunkateer Posted February 4, 2023 Share Posted February 4, 2023 (edited) A lil marvel of a high frequency-tamer. As new, boxed. Full specs & blurbage below... The Low Pass Filter pedal can be used for taming harsh high end such as fret buzz, string noise, and artifacts from other effects such as distortion pedals. It is also useful for simulating the high frequency roll-off of speaker cabinets. At it's most extreme setting, the Low Pass Filter can turn a bass guitar signal into a low end dub tone. The low pass filter is a 12 dB per octave high frequency filter. The knob controls the cutoff frequency and ranges continuously from 15 kHz to 220 Hz. The stock input impedance is 1MΩ. If you have an acoustic pickup that requires a specialized input impedance, write it in the notes during check-out, and we will accomodate the request at no extra cost. The output impedance is 100Ω. This device will work with active or passive instruments, as well as with other devices such as pedals, preamps, or effects loops. The Low Pass Filter requires a DC power supply (not included). The DC supply should be a standard Boss style connector, center negative polarity. It can accept 9 to 24 volts. Although 9 volts is sufficient for most applications, higher voltages will provide more clean headroom when using the pedal with line level signals. The current draw is approximately 10 mA. A 24 volt power supply may be purchased separately. The Low Pass Filter has a true bypass switch. Dimensions: 3.7" x 1.6" https://www.broughtonaudio.com/product-page/low-pass-filter Edited February 5, 2023 by weefunkateer Sold! 1 Link to comment Share on other sites More sharing options...
Recommended Posts