Jump to content
Why become a member? Ɨ

Piezo under saddle signal too strong


julesb
 Share

Recommended Posts

Hi all,

Ā 

I've just installed/replaced an undersaddle piezo in my previously butchered (šŸ˜€not by me!) Godin A5 and although it works, the signal is overloading my recording interface even with the gain set to minimal. I've had to turn down the volume on the onboard pre to stop it distorting. I'm sure I've made a schoolboy error so can someone tell me what it may be? I have vague memories of some sort of resistor somewhere from the pre-amp to the battery but I can't remember as this project has been on the shelf for a while and I didn't take any pics beforehand (another schoolboy error)

Ā 

Many thanks,

Jules

Link to comment
Share on other sites

  • 5 weeks later...

Piezo creates high voltages compared to a magnetic pickup. The impedance (Z) of the output is also very high, in the mega ohm range (magnetic pickup is just few kilo ohms). The preamp has to be able to tame the signal, and turn it to reasonable Z. Even if the preamp works fine, the recording interface should have a high impedance input. Usually the XLR input is for lo-Z signals like microphones. If the (jack) input has any switch for hi-Z input, use it.

  • Like 1
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
Ɨ
Ɨ
  • Create New...