yourfurryfiend Posted June 2, 2023 Share Posted June 2, 2023 Hallo! I've a Maruszczyk with Precision and a double J humbucker. The humbucker has a series/split/parallel switch. I've replaced the precision pickup with a Seymour Duncan one. The problem is I get a buzz when I touch the pole pieces. I'm assuming this is a grounding issue. The new Duncan P has foil on the back, covering the poles. I suspect that I should reverse the wires I'm connecting with the rest of the loom, so that the poles are grounded correctly? (If I remember correctly, I tried this and confirmed it was the case - it was out of phase & the buzz/hum went). If that is correct. I believe I need to also reverse the connections to the JJ humbucker or they will be out of phase? This is the exact set-up I have (see series/split/parallel): https://haeussel.com/uploads/tx_ttproducts/datasheet/Haeussel_Pickups-Wiring_Instructions_78.pdf Any idea which wires I should swap into the switch, to reverse the phase ? I've replaced various PJ pickup pickup configurations, but this goes over my head. Help would be much appreciated. Cheers! Quote Link to comment Share on other sites More sharing options...
Doctor J Posted June 7, 2023 Share Posted June 7, 2023 This is relatively common. Connect the poles to earth and you'll ground the buzz. What's happening is when you touch the poles, you become the conduit to earth. You can solder a wire to the copper foil on the back of the pickups and solder the other end to something connected to earth. If you don't fancy soldering, just ensuring a good and stable connection to earth will do it. Some manufacturers use the metal springs which push up the pickup to do it. Quote Link to comment Share on other sites More sharing options...
yourfurryfiend Posted June 9, 2023 Author Share Posted June 9, 2023 Thanks very much for the reply! That makes sense, it'll be easier to resolder/reconnect the copper foil to the wire going to earth. I didn't mention that (as I understand it) the hot wire is currently connected to the foil. Quote Link to comment Share on other sites More sharing options...
Doctor J Posted June 10, 2023 Share Posted June 10, 2023 The hot wire is white. They've already connected the foil to the ground wire so all you need to do is solder the back wire to ground and you should be fine. Quote Link to comment Share on other sites More sharing options...
yourfurryfiend Posted June 14, 2023 Author Share Posted June 14, 2023 Thanks again, much appreciated for the reply! The issue with me using the white as the hot wire, is that the P pickups will be out of phase with the JJ. What I've done in the past, when P+J pickups are out of phase, is just swap the polarity. That is difficult to do here though. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.