MuddBass Posted November 16, 2023 Share Posted November 16, 2023 Hi For pedal board linking power from my peterson tuner to power another pedal, I need a very short one of these.... ideally 8 to 10cm Must be right angle to right angle https://www.amazon.co.uk/PPBAR-R36-2-1mm-Right-Angle-Barrel/dp/B00WBSMC0K I'd really appreciate if you could pop any links etc below. Thanks Quote Link to comment Share on other sites More sharing options...
MuddBass Posted November 16, 2023 Author Share Posted November 16, 2023 This EBS is close, but a little too long: https://www.gak.co.uk/en/ebs-dc1-18-90-90-1-to-1-power-distribution-angled-cable-18cm/931887 Quote Link to comment Share on other sites More sharing options...
MartinB Posted November 16, 2023 Share Posted November 16, 2023 Rockboard do a 15cm one: https://www.rockboard.de/en/power-supplies/power-cables/power-cable-angled-angled/ 1 Quote Link to comment Share on other sites More sharing options...
MartinB Posted November 16, 2023 Share Posted November 16, 2023 Shorter than that, you may need to do it yourself: https://www.pedalpatch.co.uk/product-page/solderless-dc-kit-v2 1 Quote Link to comment Share on other sites More sharing options...
MuddBass Posted November 16, 2023 Author Share Posted November 16, 2023 Thanks for sending those links - much appreciated 1 Quote Link to comment Share on other sites More sharing options...
Downunderwonder Posted November 16, 2023 Share Posted November 16, 2023 If you are handy with a soldering iron it's pretty easy to make a power cable shorter. Snip out an over lay ie opposing short and long tails, and then trim overall length to suit. Don't forget your heat shrink. Doing it overlayed makes for only one piece of heat shrink required and a nice neat job. 2 Quote Link to comment Share on other sites More sharing options...
tauzero Posted November 17, 2023 Share Posted November 17, 2023 I've been making up some shorter power cables for one pedalboard. Because of the relative positions of power supply and pedals, I needed some right-angle to right-angle and others straight to right-angle, so I cut a few of the leads supplied with the power supply to length and soldered the appropriate half to one of these: https://www.ebay.co.uk/itm/261536704983?var=560412003886 which is a lot easier than splicing wires together. Just don't forget to put the O-ring that holds the plug together onto the lead before soldering the plug on. 3 Quote Link to comment Share on other sites More sharing options...
MuddBass Posted November 17, 2023 Author Share Posted November 17, 2023 Thanks everyone. Some good ideas there. Much appreciated. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.