MrDinsdale Posted October 5 Share Posted October 5 Just wondered if anyone had built their own pedal board using or including aluminium profile such as this: https://www.aluminium-profile.co.uk/ I was thinking a mix of this for the frame, and a 2 tier hinged section might be a fun thing to build. Quote Link to comment Share on other sites More sharing options...
Matt P Posted October 7 Share Posted October 7 I've looked at it a couple of times (I'm an R+D engineer so it's used a lot in our test environment) I couldn't find profiles that suited what i was trying to do, most of the easily available ones were too deep or just oddly proportioned. the profile isn't that cheap either so the build cost always snuck up past what was willing to spend. every time i ended up back with a commercially made pedalboard or making something from timber to suit a particular setup. Matt 1 Quote Link to comment Share on other sites More sharing options...
SamIAm Posted October 7 Share Posted October 7 This crowd have an open source design using aluminium and 3D printing. https://www.indifferentengine.com/pedalboard Sam x 2 Quote Link to comment Share on other sites More sharing options...
PaulThePlug Posted October 7 Share Posted October 7 There are some 3D printed plastic ends that you put your own wood in so -a bit adjustable for length - on the bay 1 Quote Link to comment Share on other sites More sharing options...
LukeFRC Posted October 8 Share Posted October 8 On 07/10/2024 at 12:45, Matt P said: I've looked at it a couple of times (I'm an R+D engineer so it's used a lot in our test environment) I couldn't find profiles that suited what i was trying to do, most of the easily available ones were too deep or just oddly proportioned. the profile isn't that cheap either so the build cost always snuck up past what was willing to spend. every time i ended up back with a commercially made pedalboard or making something from timber to suit a particular setup. Matt How well did you find timber worked weight wise? I’ve got a lovely posh voodoo lane pedal board - but fancy something a little larger and thinking of building something 1 Quote Link to comment Share on other sites More sharing options...
Matt P Posted October 9 Share Posted October 9 10 hours ago, LukeFRC said: How well did you find timber worked weight wise? I’ve got a lovely posh voodoo lane pedal board - but fancy something a little larger and thinking of building something Timber isn't too bad for weight but I was always building to fit the carrying case which was heavy, this was the main reason to go back to a commercial board. Having something to carry the board in was always the challenge for me as I like stuff to be properly protected. Matt 1 1 Quote Link to comment Share on other sites More sharing options...
MrDinsdale Posted October 11 Author Share Posted October 11 (edited) On 07/10/2024 at 12:45, Matt P said: I've looked at it a couple of times (I'm an R+D engineer so it's used a lot in our test environment) I couldn't find profiles that suited what i was trying to do, most of the easily available ones were too deep or just oddly proportioned. the profile isn't that cheap either so the build cost always snuck up past what was willing to spend. every time i ended up back with a commercially made pedalboard or making something from timber to suit a particular setup. Matt Yeah that makes sense, pretty much what I suspected! I think I’ll keep an eye out for any off cuts on eBay to possibly make a little hinged pedal raiser/shelf perhaps rather than a full board. Might just use some plywood offcuts I’ve got knocking around, though 👌 I did have a hacked together raise, but it's a pain to access pedals under, and it'd be nice if it looked a little better! Edited October 11 by MrDinsdale Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.