Pow_22 Posted November 11 Share Posted November 11 (edited) I have been borrowing our rehearsal spaces SVT 3 pro whilst i source a decent pre-amp/DI pedal and encountered an issue at our last gig. Mid set it cut out, the power light remained on but the gain/peak light wasn't blinking as if the amp wasn't receiving signal. It seemed to kick back in and out a few times and i eventually finished the gig on a DI box via FOH. Immediate thoughts were cables but upon setting the amp back up at home with the same cables i was unable to recreate the issue. This leads me to think it may have been an over heating issue (i was unable to crank it at home). However, on opening the amp up i noticed that there was a 12AX7 in place of the 12AU7 so i immediately replaced that. Is there any reason why using the wrong valve here would make it cut out? Could understand it not sounding great but would a wrong valve here cause overheating/cutting out issues? Edited November 11 by Pow_22 Quote Link to comment Share on other sites More sharing options...
ghostwheel Posted November 11 Share Posted November 11 4 hours ago, Pow_22 said: I have been borrowing our rehearsal spaces SVT 3 pro whilst i source a decent pre-amp/DI pedal and encountered an issue at our last gig. Mid set it cut out, the power light remained on but the gain/peak light wasn't blinking as if the amp wasn't receiving signal. It seemed to kick back in and out a few times and i eventually finished the gig on a DI box via FOH. Immediate thoughts were cables but upon setting the amp back up at home with the same cables i was unable to recreate the issue. This leads me to think it may have been an over heating issue (i was unable to crank it at home). However, on opening the amp up i noticed that there was a 12AX7 in place of the 12AU7 so i immediately replaced that. Is there any reason why using the wrong valve here would make it cut out? Could understand it not sounding great but would a wrong valve here cause overheating/cutting out issues? A wrong valve shouldn't have had such an effect. As far as I understand the schematic, this valve doesn't amplify the signal being a White cathode follower. You'd probably be better off letting check the amp by a specialist. Here some stuff might be helpful: https://groupdiy.com/threads/ampeg-svt3-pro-bass-amp.58157/post-740378 1 Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.