Jump to content
Why become a member? ×

Arkham Zephyr Preamp (B15)
£850
Montreuil (93100) France


Grossmit
 Share

Recommended Posts

Selling this rare and amazing Arkham Zephyr Bass preamp.

B15 preamp with some twists, sounding majestic, highest craftmanship and components. 230v version.


12AX7 preamp tube selected for low noise and good tone, run at 300V B+ (not a starved plate design).

Buffered Lo-Z output, drives modern solid state power amps or recording interfaces with ease

Gain, Treble, Bass controls - uses a James Tonestack to provide a wide adjustment range with minimal interaction

Range control sweeps the tonestack "midpoint" anywhere between 150Hz and 1KHz

Hi switch adds a "bright cap" to the circuit to open up the high frequencies a bit

Mid switch gives a +3dB boost at 150Hz

Lo switch gives a +6dB boost at 80Hz

HPF switch - Passive filter (-6dB/Octave) set at 100Hz

Mute switch - sweet silence at the flick of a switch

Low impedance output, with an additional thru jack for splitting your Bass signal to another amp

Balanced DI output, featuring an excellent Cinemag transformer for full frequency response. Ground lift switch for good measure

Separate master volumes for preamp out and balanced out. Lets you dial in some grit, and adjust stage volume to the board

DC referenced heaters, for ultra quiet operation

Turret board construction, Mil-spec Teflon wire, etc.

Carling switches, Switchcraft jacks, Belton sockets, etc.

Powder-coated steel 1U chassis. Weighs ~8 lb.

 

shipped with extra care

IMG_4017.jpeg

IMG_4018.jpeg

IMG_4019.jpeg

IMG_4020.jpeg

IMG_4021.jpeg

IMG_4022.jpeg

IMG_4026.jpeg

IMG_4028.jpeg

IMG_4029.jpeg

  • Like 3
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...