3d printed pedal risers - Any size - Almost free :) £1

[rwillett]

Hi

To help  @AndyTravis's fund raiser for his daughter, I'm happy to 3D print pedal risers for your pedalboard. This is an idea from @LukeFRC so can't take much credit for this.

 

These will be made to measure, so don't worry if you have an odd sized pedal (oohherr missus), I'll print them to fit. I'll even supply genuine Velcro and post for free. All you have to do is make a donation to the fund here

 

 

In the best Blue Peter tradition, here's a few I made earlier.

 

The small one is for a Petersen Tuner but suspect its a similar size to the Boss pedals (of which I have none), its 125mm x 64mm x 25mm high.

 

Here's the side view where you can see the cable holes. The holes are 15mm.

 

 

This is for a Mod Dwarf (200mm x 100mm x 25mm) and has screw holes to connect it to aluminium extrusion. I have a home made pedal board, I wouldn't expect you to need screw holes so I'd remove them for you.

 

 

This is for an IK Media ToneX pedal (170mm x 140mm x 25mm), note that its slightly H-shaped as the pedal is quite wide and not very long. Again I have screw holes but I'd remove these.

 

 

The cable holes allow you to hide the cables underneath the pedal which is nice.

 

I'll do these for a £5 donation for the small pedals and a £10 donation for the large pedals. I'll throw the Velcro in and do free postage as well. Every penny goes to the fund.

 

As these are printed individually, it's zero effort to change them to exactly the size you want, length and width and height, I can also do them in black, red, white, sparkly blue. I can also remove the cable holes, change the size. I'd remove the screw holes as well as they are specific for me.

 

Thanks for looking

 

Rob

Edited yesterday at 10:25 by rwillett

[stewblack]

Brilliant idea.