Eq'ing a vocal on digital mixer (XR18)

[Steve Browning]

This is a more general question, which is why it's not in the Behringer thread.

 

The mixer allows eq at 3 stages overall. Channel, monitor and FoH. I would expect (within a little), the first 2 can be pretty well set, with the FoH eq being tweaked for the room at each gig (if necessary).

 

My question is with regard to the channel eq. Can this be set while using cans? It strikes me it's more to do with the actual sound of the voice and, if that's the case, wouldn't cans work at this stage, with the overall FoH eq compensating for the effects of the room you're in? It seems logical to me, but I'm barely a novice at this.

 

Any advice gratefully received.

[Dan Dare]

Yes. Engage the PFL (pre-fade listen) on the channel whilst setting eq on cans and you should hear just the channel eq. You may have to set the signal sent to the cans to hear the individual channel, rather than the sound from the master eq.

 

It's best to use closed-back cans for the job, so you hear as little of the room sound as possible.

 

 

Edited 7 hours ago by Dan Dare

[Steve Browning]

Thank you for the confirmation. This what I had expected (and hoped).

[Dan Dare]

It's a pleasure. You probably do this already, but I find it best to set channel eqs with the FOH and monitors turned down. You may have to ignore "Can't hear myself" protests from the singer. Ask them to sing as loudly as they would when the band is playing, too. Once you have it dialled in the cans, you can use the master eq to adjust for the room.

Edited 7 hours ago by Dan Dare