lemmywinks Posted January 6, 2010 Share Posted January 6, 2010 A while ago i took my problematic Superfly out of it's horrid casing and have been using it quite a bit with no problems. I added some rubber feet to it but the corners are way too sharp so i'd like to fit some small rubber/plastic/metal corners to it I can't seem to find any small enough, most places just sell the standard PA cab corners which are far too big. Anybody know where i can get some? Maybe even the rail type edges like the old Hartke amps had before they cased them? Ta in advance! Quote Link to comment Share on other sites More sharing options...
Mykesbass Posted January 6, 2010 Share Posted January 6, 2010 [url="http://www.adamhall.com/uk/AH_p--project_27__b--4072"]http://www.adamhall.com/uk/AH_p--project_27__b--4072[/url] and then check out the stockist link. Quote Link to comment Share on other sites More sharing options...
lemmywinks Posted January 6, 2010 Author Share Posted January 6, 2010 Had a look through those and the only ones they have are the usual large plastic or metal ones for cabs. Starting to think it'll be easier to buy some plastic extrusion and attach it to the edges Quote Link to comment Share on other sites More sharing options...
Cat Burrito Posted January 6, 2010 Share Posted January 6, 2010 At the risk of being obvious there are quite a few listed on EBay and many more from the International sellers. Surely something there would fit? Quote Link to comment Share on other sites More sharing options...
2x18 Posted January 6, 2010 Share Posted January 6, 2010 What about these stainless ones at the bottom of this page, and dont forget postage is included! [url="http://www.axesrus.com/AXEBASE.htm"]http://www.axesrus.com/AXEBASE.htm[/url] Will. Quote Link to comment Share on other sites More sharing options...
lemmywinks Posted January 6, 2010 Author Share Posted January 6, 2010 Pretty much everything i've seen is for cabinets or large heads with rounded wooden corners, the Ashdown without the extra casing is about the same size as a LMII so they would dwarf it The standard size plastic stackable corners and the guitar cab-style metal corners are very big compared to the amp I've been looking for lengths of rubber extrusion of a suitable width i could cut to size but no joy Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.