Jump to content
Why become a member? ×

Edirol UA 5, 24bit USB Audio Interface


Recommended Posts

UA 5

I've owned this from new, its never been out my home studio and offers superb sound quality. VERY GOOD condition and full working order. Specs below. Just checked tonight and this is still supported to Windows 7 and Mac OS 10.6. Comes ith power supply and install disc but you will need to download the updated drivers.

I dont know [size=6][b]£50 plus p+p
[/b][/size]


EDIROL UA-5 24bit 96khz USB audio interface

Two high quality microphone pre-amps with balanced (XLR) and 1/4-inch (TRS) inputs
Switchable phantom power (48 VDC)
Two Line-level analog inputs (-10 dBu) with level control
Two pairs of Line-level analog outputs (RCA and 1/4-inch)
Two A-to-D converters that operate up to 24-Bit data words and 48 KHz sampling rates (full duplex) and 96 KHz (half duplex)
S/PDIF Optical (Toslink) and Coaxial (RCA) Inputs and Outputs (selectable)
and a USB slave interface.
The UA-5 can feed PC- or Mac-compatible computers via its USB interface. (The UA-5 is not designed to be used as a stand-alone mic pre-amp/A-to-D converter; see the M-Audio Duo for that application.)


Phantom Power

The UA-5 provides 48 Volt phantom power to microphones that need it; the phantom power can be switched on or off via a front panel push button when not required. (A single pushbutton controls both channels.)
Zero Latency Monitoring

The UA-5 provides zero-latency monitoring: you can monitor the recorded audio in real-time via its variable level headphone output. The 1/4" headphone jack and level control are on the front panel.
Overload Indicator

The Duo's front panel provides a single Peak LED to indicate when you're feeding either channel too hot a signal.
SCMS

When recording via its analog inputs, the UA-5 acts as a professional device and does not impose SCMS restrictions on its S/PDIF output data stream unless you specifically impose it via your host computer.
When recording via the S/PDIF digital inputs, the UA-5 passes along the SCMS state in the data stream without modification.

Note: The UA-5 is not bit-for-bit accurate in transferring digital data to the computer via its S/PDIF input.

Sample Rate Conversion

The UA-5 offers real-time sample rate conversion in hardware, the only device of its type to do so.
High Impedance Input

The second XLR input can be switched to accept a high impedance input source, like an electric guitar.
Specifications

Dynamic Range: 99 dB (A-to-D converter), 108 dB (D-to-A converter)
Noise Level: -95 dBu or less (analog output)
Max mic input level: 0 dBu
Mic input gain range: 50 dB
Line level output: -10 dBu
Variable level headphone output
Power Requirement: 9 VDC at 450 milliAmps
Size: 8-5/8(W)x 5-7/16(D)x 1-7/8(H) inches [218(W)x 137(D)x 46.5(H) mm]
Weight: 1 pound 10 ounces [.71 kg]

Minimum System Requirements

Windows
Windows ME, 98SE, 2000 Professional
USB port (Intel chipset preferred)
Pentium, Celeron, Intel-compatible, 400 MHz (500 MHz for 2000 Pro)
64 MB RAM (128 MB for 2000 Pro)
100 MB hard disk storage
"Note to PC users: "INTEL", "ALI" or "Lucent" USB chipsets are recommended.
Incompatible USB chipsets: VIA Apollo BX, VIA Apollo MVP3, VIA Apollo MVP4, VIA Apollo Pro, VIA Apollo Pro Plus, VIA Apollo Pro133A, VIA Apollo Pro133, VIA Apollo KT133, VIA VT 83C572/VT82C586, VIA Tech, VIA Rev5, Standard Open HCD, OPTi 82C861, SiS7001, NEC Open HCD Controller, Compaq PCI to USB Open Host Controller."

Macintosh

MacOS 8.6 and 9.x (MacOS 9.0.4 required for Sound Manager)
USB port
PowerPC G3/300 MHz or higher
128 MB RAM
100 MB hard disk storage

Edited by cd_david
Link to comment
Share on other sites

  • 2 weeks later...
Guest
This topic is now closed to further replies.
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.
×
×
  • Create New...